What is the fit selection for rolling imported bearings?

2025-11-08 13:43

The basis for choosing cooperation


According to the rotation of the load acting on the imported bearing relative to the ring, the loads borne by the imported bearing

ring can be classified into three types: local load, cyclic load and swing load. Generally, for cyclic loads (rotational loads) and oscill

ating loads, tight fits are adopted. Except for special requirements in use, local loads generally should not be tightly fitted. When

the imported bearing rings are subjected to a static load and it is a heavy load, both the inner and outer rings should adopt an

interference fit. However, sometimes the outer ring can be slightly looser and should be able to move axially in the bore of the

imported bearing housing. When the imported bearing rings are subjected to swinging loads and the loads are relatively light,

a fit slightly looser than the tight fit can be adopted.


(2) Load magnitude


The interference fit between the imported bearing ring and the shaft or housing hole depends on the magnitude of the load.

When the load is heavy, a larger interference fit is adopted. When the load is light, a smaller interference fit should be adopted.

The general radial load P is less than 0. At 07C, it is a light load with P greater than 0. 07C is equal to or less than 0. At 15 ° C,

it is the normal load, and P is greater than 0. At 15 ° C, the load is heavy (C is the rated dynamic load of the bearing).


• Working temperature


When imported bearings are in operation, the temperature of the rings is often higher than that of adjacent parts. Therefore,

the inner ring of the imported bearing may loosen from the shaft due to thermal expansion, and the outer ring may affect

the axial movement of the bearing in the housing hole due to thermal expansion. When choosing the fit, the temperature

difference and expansion and contraction of the imported bearing device part should be taken into account. When the tem

perature difference is large, the interference fit between the shaft and the inner ring should be larger.


• Rotational accuracy


When there is a high requirement for rotational accuracy of imported bearings, to eliminate the influence of elastic deformation

and vibration, clearance fits should be avoided.


The structure and material of the bearing housing hole


When the form housing hole is fitted with the outer ring of the bearing, an interference fit should not be adopted, nor should the

outer ring rotate within the housing hole. For bearings installed in thin-walled housing holes, light metal housing holes or hollow

shafts, a tighter fit than that in thick-walled housing holes, cast iron housing holes or solid shafts should be adopted.


• Easy to install and disassemble


For heavy machinery, loose fit bearings are recommended. When a tight fit is required, separable bearings, bearings with conical

bores on the inner ring, and bearings with tight sleeves or withdrawal sleeves can be selected.


Axial displacement of the bearing


During the fit, when it is required that one ring of the bearing can move axially during operation, the outer ring of the bearing and

the housing hole of the bearing housing should adopt a loose fit.


The choice of coordination


The fit between the bearing and the shaft adopts the base hole system, while the fit with the housing adopts the base shaft system.

The fit between the bearing and the shaft is different from the tolerance fit system adopted in the machinery manufacturing industry

The tolerance zone of the inner diameter of the bearing is mostly below zero. Therefore, under the same fit conditions, the mix ratio

between the inner diameter of the bearing and the shaft is usually tighter. Although the tolerance zone of the outer diameter of the

bearing and that of the central shaft in the base shaft system are both below the zero line, their values are also different from those

of the general tolerance system.